Stock Track Bar Bracket Replacement for Jeep TJ / LJ / XJ / ZJ Front Axle

On a Jeep TJ, LJ, XJ, or ZJ, the thin factory front track bar bracket is a known failure point: the mounting hole wallows out over time, the axle starts shifting under the bar, and death wobble follows. Artec's replacement bracket is laser cut from 1/4" mild steel and welds on in place of the original, restoring a tight, solid mount on the front Dana 30 or Rubicon Dana 44 — and it carries the factory sway bar mount at stock height while it's at it. The tab-and-slot design self-aligns the three-piece assembly so the welding goes where it should.

Features

• Heavy 1/4" mild steel resists the hole-wallowing that kills factory brackets
• CNC laser cut and bent with self-aligning tab-and-slot construction
• A proven fix for death wobble caused by a worn factory track bar mount
• Carries the factory sway bar mount at stock height
• Keeps stock track bar geometry for factory-steering rigs
• Works alongside an Artec front axle truss
• Bare steel, made in the USA

Fits the front Dana 30 and Rubicon Dana 44 under the Wrangler TJ/LJ (1997-2006), Cherokee XJ, and Grand Cherokee ZJ. Installation means cutting the factory bracket off the housing and welding this one on, so plan for fabrication skills, a fresh alignment afterward, and primer and paint over the bare steel. Reinforce the whole housing with the Front Axle Truss for TJ, LJ, ZJ, or if you run crossover steering or added lift, look at the Raised Track Bar Bracket for TJ Front Axle. More options: track bar brackets.