Superduty Crossover Steering Kit with 7/8" JMX Rod Ends
This kit supplies everything needed to build the tie rod and drag link for a Ford Super Duty Dana 60 crossover steering conversion: JMX 7/8" rod ends, wrench-flat tube adapters, jam nuts, high-misalignment spacers, and heavy 1.5" OD x 1/4"-wall 1026 DOM tubing. It is the purpose-matched companion to Artec's Superduty crossover weld-on high steer arms, giving a swapped one-ton front end linkage that stands up to big tires instead of factory-style bent rods.
Features
- JMX 7/8" rod ends with heat-treated races for the tie rod and drag link
- 7/8"-to-3/4" high-misalignment spacers included
- 1.5" OD x .250" wall 1026 DOM tubing: 48" drag link and 54" tie rod blanks
- Builds an uncut drag link around 54" and a tie rod around 59-60" overall
- 7/8"-14 tpi wrench-flat tube adapters and jam nuts for easy toe adjustment
- Made in the USA
This is a build kit, not a bolt-on: you cut the DOM to your measurements, drill or ream the pitman arm to 3/4", and weld the tube adapters, then set toe-in to roughly 1/16"-1/8". It is made to run with the 99-04 or 05+ Crossover Weld-On High Steer Arms; if you want bolt-in aluminum links for Reid knuckles instead, see the Superduty Swap Aluminum Steering Kit. Browse the full tie rod lineup.
Complete your Super Duty build
More parts that fit your Super Duty and pair well with this one — matched and ready to install.
$516.99
$82.49
$318.99
$39.99
$59.99
More for your Ford Super Duty
Pulled from the 867 products that fit your Ford Super Duty — so every item here is guaranteed to fit. No sorting through parts that don’t.
Specifications
Superduty Crossover Steering Kit with 7/8" JMX Rod Ends FAQs
What high steer arms does this kit pair with?
It is designed around Artec's Superduty crossover weld-on high steer arms for 1999-2004 and 2005+ knuckles, and it complements Artec's Super Duty Dana 60 swap kits. The rod ends, spacers, and tube lengths are matched to that arm geometry.
How much fabrication should I expect?
Plan on cutting the DOM tubing to your measured lengths, drilling or reaming the pitman arm to 3/4", threading the adapters, and welding the tube adapters into the links. After assembly, set toe-in to about 1/16"-1/8" and torque the jam nuts.
How long can the finished links be?
The supplied 48" and 54" DOM blanks build a drag link up to roughly 54" and a tie rod up to roughly 59-60" overall before trimming. Measure your knuckle-to-knuckle and pitman-to-arm spans first to confirm that covers your axle width.
Multi-column
Join Our Community
For all things NVMOS, check us out on Instagram and Facebook!
Financing Available
Buy now and pay later with Affirm.
Contact Us
Have a question? Just send us an e-mail at support@nvmos.com
