Unit Bearing Tool for 1999-2004 Ford Super Duty Dana 60
The Artec Unit Bearing Tool is a DIY weld-together fixture that lets you pull apart the front unit bearings on a 1999-2004 Ford Super Duty Dana 60 so you can swap ABS tone rings — the step that trips up most one-ton front axle swaps into a JK. Rather than paying for a one-off press setup or a machine shop visit, you weld the supplied laser-cut plates together along the etched guide lines and run the tool with a 1/2" drive impact. It is a reusable shop fixture, so it stays useful across every Super Duty bearing you service after the swap.
Features
- CNC laser cut from 3/16" and 1/4" mild steel plate
- Includes a 3/16" AR hardened plate for the impact-drive surface
- Laser-etched guide lines let you weld the stack concentric and true
- Works with a standard 1/2" drive impact driver
- Purpose-built for 99-04 Super Duty unit bearing disassembly and tone-ring changes
- DIY weld-together format keeps the cost far below a dedicated press fixture
Verify your axle is the 1999-2004 Super Duty Dana 60 front — the 2005-up unit bearing differs — and plan on welding the plates yourself before first use; work carefully, because forcing the tool can damage a bearing, and some tone rings still need a puller or press to come fully free. If you are matching tone rings to a JK swap, pair it with the 1-ton 52-tooth tone rings, and find more swap hardware in replacement axle parts and tools or the full Artec Industries lineup.
Complete your Super Duty build
More parts that fit your Super Duty and pair well with this one — matched and ready to install.
$36.29
$82.49
$39.99
$59.99
$59.99
More for your Ford Super Duty
Pulled from the 943 products that fit your Ford Super Duty — so every item here is guaranteed to fit. No sorting through parts that don’t.
Specifications
Unit Bearing Tool for 1999-2004 Ford Super Duty Dana 60 FAQs
What does this tool actually do?
It lets you disassemble the front unit bearings on a 1999-2004 Ford Super Duty Dana 60 so you can change the ABS tone rings — typically to match a 52-tooth JK count during a one-ton front axle swap — and then reassemble them. Without it, that job usually means a press fixture or a machine shop.
Do I have to weld it together myself?
Yes. It ships as laser-cut plates that you weld into the finished fixture, following the laser-etched guide lines so everything stays concentric. That DIY format is what keeps the price low, and once welded the tool is reusable indefinitely.
What else do I need to finish the job?
A standard 1/2" drive impact driver runs the tool. Work deliberately — improper use can damage a unit bearing — and be aware that some tone rings still need a puller or press to come fully off the bearing after disassembly.
Multi-column
Join Our Community
For all things NVMOS, check us out on Instagram and Facebook!
Financing Available
Buy now and pay later with Affirm.
Contact Us
Have a question? Just send us an e-mail at support@nvmos.com
