Frame-Side Track Bar Mount for Jeep Wrangler TJ / LJ (2.5"-3.5" Stretch)

Stretch the front axle forward on a Jeep TJ or LJ — especially under a one-ton swap — and the factory frame-side track bar mount ends up in the wrong place entirely. This Artec mount replaces it with a 1/4" steel frame plate and sliding bracket that relocate the panhard anchor 2.5" to 3.5" forward of stock. The plate contours the factory frame and locates off an existing frame hole, the bracket slides fore-and-aft on the plate to fine-tune position, and three holes spaced 1.3" apart set your track bar height against the drag link.

Features

• 1/4" steel, CNC laser cut and bent, engineered from 3D scan files
• Relocates the frame-side track bar mount 2.5" to 3.5" forward of factory
• Contours the factory frame and indexes off an existing frame hole
• Sliding track bar bracket fine-tunes location on the frame plate
• Three hole positions spaced 1.3" apart for steering and track bar geometry
• Run the top two holes and trim the bracket bottom for extra clearance
• 1.75" mounting width fits 7/8" x 3/4" rod ends with high-misalignment spacers
• Made in the USA

Fits the Wrangler TJ (1997-2006) and LJ Unlimited (2004-2006) on stretched builds — it pairs naturally with the TJ 1-Ton Front 60 Swap Kit. Note it is sized for rod ends, not a factory rubber joint, and it is a weld-on part: clean, prime, and paint the frame area after welding, then verify your alignment. Match the axle end with the Raised Track Bar Bracket for TJ Front Axle, and find every option in track bar brackets.