Adjustable Truss Upper Link Mount (Single) for 3-Link and 4-Link Axle Trusses

The Artec Industries Adjustable Truss Upper Link Mount is a weld-on steel bracket that locates the upper control link on a trussed axle housing. CNC cut and bent from 1/4" mild steel, it lands on any flat surface—most commonly the top of an Artec axle truss—and lets you fine-tune upper-link angle and pinion position before anything gets burned in. That adjustability matters on a custom three-link or four-link, where small changes in link placement decide how the axle behaves under throttle and articulation. It is a universal fabrication piece for Jeep, Toyota, and scratch-built housings, sold as a single mount so you order exactly what your link layout needs.

Features

• CNC cut and bent from 1/4" mild steel for a stout upper-link attachment point
• Adjustable link position to dial in upper-link angle and pinion setup
• Welds to any flat surface, including Artec axle trusses
• Clean laser-cut edges and formed geometry for accurate fit-up
• Universal design suits three-link and four-link builds on Jeep, Toyota, or custom axles
• Bare steel, ready to weld and finish
• Sold individually—order one per upper link in your setup

This is a fabrication component, not a vehicle-specific bolt-on: mock up your link geometry, tack it in place, and check pinion angle through the travel cycle before final welding, then paint or powder coat the bare steel. It pairs naturally with a full-length housing truss such as the Modular Rear Truss - 60 or the Front Axle Truss for TJ, LJ, ZJ, and you can browse more axle reinforcements or the full Artec Industries lineup.