Adjustable Link Tower (Single)

The Artec Adjustable Link Tower raises an upper-link mounting point off the axle tube — and unlike a fixed tab, it lets you fine-tune link height and angle while you dial in the suspension. That adjustability matters when you are chasing roll center, anti-squat, and pinion behavior on a custom 3-link or 4-link: you can move the joint instead of cutting brackets off and starting over. The wide base spreads load into the axle tube rather than concentrating it the way a narrow C-channel tower does, and the whole piece carries the clean, finished look of Artec's bracket line.

Features

• Adjustable mounting point for tuning upper-link height and angle
• Wide base spreads suspension loads into the axle tube
• Contoured for a 3.0" or 3.25" diameter axle tube — choose your size
• Sold as a single tower, so you buy exactly what your link layout needs
• Cleaner, stronger alternative to generic C-channel link towers
• Weld-on installation for a permanent, structural mount

This is a universal fabrication part, not a vehicle-specific bolt-on — measure your axle tube and order the 3.0" or 3.25" version to match. Installation calls for structural welds by someone experienced with suspension fabrication, and the bare steel should be painted once welded. Hang the lower bars from the Lower Link Axle Brackets or, on one-ton housings, the Dana 60 Lower Link Axle Brackets. If your upper links mount to a truss instead of the tube, see Artec's Adjustable Truss Upper Link Mount, and browse more in axle reinforcements.