Pack dirt bikes close together on a chase rack and two problems show up fast: handlebars that tangle and a tailgate that won't latch. The Moto Offset Adapter fixes both. It scoots the moto 4" toward the cab for the best shot at a closed tailgate, and it staggers bar height so bikes running side by side on Motorcycle/eMoto Mounts never touch.
Features
- Two mounting positions: angled (3.5" forward, 1.4" vertical offset) runs the front tire on the front track to push the bike as far forward as possible; straight (2.8" vertical offset) lifts the bike higher and shifts the whole moto toward the cab
- 1/4" aluminum construction — 3 lbs, 10" x 3" x 4"
- Secures to the upper crossbar with standard T-track hardware
- Carriage-bolt-and-lock-nut design resists loosening on washboard roads
How many you need comes down to bed length, not truck model. For three motos, Big Days recommends two adapters on beds over 5'5" and three on beds under 5'5"; for two motos, none over 5'5" and two under. This listing is a single adapter — if you're adding a third bike, the Moto Offset Kit bundles two. Pair it with the In-Bed Moto Ramp to make loading just as painless as hauling.
Moto Offset Adapter Single FAQs
How many offset adapters do I need?
It depends on bed length and bike count. For three dirt bikes, Big Days recommends two adapters on beds over 5'5" and three on beds under 5'5". For two dirt bikes, you need none on beds over 5'5" and two on shorter beds. This listing covers a single adapter; the Moto Offset Kit bundles two.
What is the difference between the angled and straight positions?
The angled position gives a 3.5" forward and 1.4" vertical offset and lets the front tire run on the front track, getting the bike as far forward as possible. The straight position gives a 2.8" vertical offset, lifting the bike higher while scooting the whole moto closer to the cab.
How does the adapter install on the rack?
It secures to the upper crossbar using standard T-track hardware with a carriage-bolt-and-lock-nut design, so hardware stays put instead of vibrating loose on rough roads. The adapter itself is 1/4" aluminum at 3 lbs and measures 10" x 3" x 4", and it can be set in either the angled or straight position.
Multi-column
Join Our Community
For all things NVMOS, check us out on Instagram and Facebook!
Financing Available
Buy now and pay later with Affirm.
Contact Us
Have a question? Just send us an e-mail at support@nvmos.com
