TJ Trackbar Mount - Frame Side (2.5" - 3.5" Stretch)
This frame-side Track Bar Mount replaces the factory Jeep TJ/LJ track bar bracket and relocates the mounting point 2.5" to 3.5" forward. It is built for stretched and 1-ton-swapped builds that need added clearance and a stronger, adjustable panhard anchor on the frame.
Key Features
- Heavy-duty replacement for the factory frame-side track bar mount
- Allows a 2.5" to 3.5" stretch forward of the factory position
- Contours to the factory frame and locates off a factory frame hole for easy positioning
- The track bar bracket slides forward or back on the frame plate to fine-tune location
- Three hole locations spaced 1.3" apart to dial in steering and track bar geometry
- Using the top two holes lets you trim the bottom of the bracket for extra clearance
- 1.75" mounting width fits 7/8" x 3/4" rod ends with high-misalignment spacers
Fitment & Compatibility
Fits the Jeep Wrangler TJ (1997-2006) and LJ Unlimited (2004-2006). It is designed to work with a forward axle stretch and pairs well with the TJ 1 Ton Front 60 Swap Kit for added clearance. It uses a 1.75" mounting width for 7/8" x 3/4" rod ends with high-misalignment spacers and will not work with a factory replacement (rubber) joint. For the axle end, see the Raised Track Bar Bracket for the TJ Front Axle.
Specifications
| Specification | Detail |
|---|---|
| Type | Frame-side track bar mount (replaces factory) |
| Stretch range | 2.5" to 3.5" forward |
| Hole positions | 3 locations, 1.3" apart |
| Mounting width | 1.75" (7/8" x 3/4" rod ends w/ high-misalignment spacers) |
| Construction | Heavy-duty steel, weld-on |
What's in the Box
- Frame-side track bar mount / frame plate
- Sliding track bar bracket with 3 hole positions
Frequently Asked Questions
What Jeeps does this fit?
It is designed for the Jeep Wrangler TJ (1997-2006) and LJ Unlimited (2004-2006), particularly builds with a forward axle stretch.
How much stretch does it allow?
It relocates the frame-side track bar mount 2.5" to 3.5" forward of the factory position.
What rod end does it take?
The 1.75" mounting width is sized for 7/8" x 3/4" rod ends with high-misalignment spacers. It will not work with a factory-style replacement joint.
Is welding required?
Yes. It contours to and welds onto the frame, and it locates off a factory frame hole to help position it before welding.
Multi-column
Join Our Community
For all things NVMOS, check us out on Instagram and Facebook!
Financing Available
Buy now and pay later with Affirm.
Contact Us
Have a question? Just send us an e-mail at support@nvmos.com
