Superduty High Steer Cap-Spacer

The Super Duty High Steer Cap-Spacer is a simple, tough 1/4" steel plate from Artec Industries that raises the mounting height of a Super Duty high steer arm on a Reid Racing knuckle, or acts as a flat cap over the top of the knuckle. It is a small fabrication piece that solves clearance and geometry problems on a one-ton crossover steering build.

Key Features

• Laser-cut from 1/4" steel for a strong, durable spacer or cap
• Lifts a Super Duty high steer arm to fine-tune drag link angle and clearance
• Doubles as a cap for the top of a Reid Racing Super Duty knuckle
• Works on either the driver or passenger side
• Bare steel finish, ready to run or coat

Fitment & Compatibility

Designed for Reid Racing Super Duty knuckles used in one-ton front axle swaps. It is a symmetrical part that fits the left or right side. Use it alongside the Super Duty Swap Aluminum Steering Kit and the Spacer Adapters for the Super Duty High Steer Arm to complete your crossover steering geometry.

Specifications

What's in the Box

• 1 x Super Duty high steer cap-spacer (1/4" bare steel)

Frequently Asked Questions

What does this spacer do?
It either raises the height of your Super Duty high steer arm on a Reid Racing knuckle, or caps the top of the knuckle. Raising arm height lets you dial in drag link angle and component clearance.

Which knuckle does it fit?
It is made for Reid Racing Super Duty knuckles, and it works on either the driver or passenger side.

Is hardware included?
No. Hardware is not included, but the 1/2"-20 tpi thread it uses is a common size available at any hardware store. ARP studs are not necessary when the part is used simply as a cap.