2024+ Jeep Wrangler JL/4xe & Gladiator JT LINK™ Grab Bar Mount With MagSafe Charging Phone Holder & 3.5" Arm
For qualified buyers at checkout
Secure checkoutEncrypted payment
Warranty Information
Vendor warranty summary
Tackform Warranty
At a glance: Lifetime on metal parts, 3 years on plastic, 1 year on electronics
This is Tackform's warranty, not an NVMOS policy. We've summarized it in plain English to save you a search. The manufacturer's official terms always govern and can change without notice. Last reviewed on nvmos.com: October 4, 2026.
Coverage by product
| Product or component | Coverage |
|---|---|
| Metal parts | Lifetime |
| Plastic/ABS parts | 3 years |
| Electronics | 1 year |
- Keep your NVMOS order confirmation — proof of purchase is required.
What's covered
- Tackform mounts and their parts bought from Tackform or an authorized reseller
- Only the defective component is replaced, not the whole system
What's not covered
- Devices you attach (phones, GPS units, tablets)
- Abuse, misuse or exposure to extreme temperatures
- Normal wear and tear
- Modified or improperly used mounts
- Discontinued parts with no available replacement
How to make a Tackform warranty claim
- Email clear photos of the mount and the failed area
- Explain how and when it failed
- Include proof of purchase (order number, Amazon order or receipt) and your shipping address
- A small shipping charge applies based on part weight; international customers pay all shipping
Tackform contact: Email: support@tackform.com · Claim page / support
Bought it from NVMOS? Start with us.
Have your order number and a few photos of the issue ready, then call real humans at (920) 249-7744 or send us a message. We'll tell you whether the claim goes through us or straight to Tackform, and help it along either way.
Shop Tackform at NVMOS
TRAXX™ - Accessory Track Dash Bracket With Dual MagSafe Phone Mount | 2014-2018 Chevrolet Silverado & GMC Sierra, 2015-2019 Silverado HD & Sierra HD
TRAXX™ -Accessory Track Dash Bracket With Dual MagSafe Phone Cradles | 2009-2012 RAM 1500 & 2500/3500
TRAXX - Slim Track Dash Bracket With 20LITE Phone & Midland Magnetic CB Radio Mic Mounts | 2016 - 2023 Toyota Tacoma
See all Tackform products, lead times and FAQs →
Disclaimer: The information on this page describes Tackform's own warranty policy. It is not a warranty offered by NVMOS (No Visible Means of Support LLC). Manufacturers update their terms at any time; we review these pages periodically, but the manufacturer's current official policy is the one that applies to your claim. Source: Tackform official warranty information. Last updated on nvmos.com: October 4, 2026. See our return policy for NVMOS's own terms.
About the brand
Tackform (often typed as Trackform) has built heavy-duty device mounts in Addison, Illinois since 2012. NVMOS carries their TRAXX dash brackets, 20 Series phone mounts (including MagSafe), tablet and monitor holders, CB mic holders, camera holders and bases for trucks, vans and off-road rigs where the phone needs to stay put.
Based in: Addison, Illinois · Founded: 2012 · Lead time: In-stock ships in 24–48 hrs
Shop all 1901 TackformWarrantyAll brands
Warranty terms are set by Tackform, not NVMOS, and can change. Bought from us? Call (920) 249-7744 and we'll handle the claim with the brand.
The passenger grab bar on a 2024-and-up Wrangler or Gladiator is a good place for a phone: within reach, out of the driver's sight line, and it leaves the dash alone. Tackform's LINK grab bar mount uses that spot, with a MagSafe charging phone holder on a 3.5-inch arm.
Instead of wrapping a clamp all the way around the bar, the LINK mount uses a C-clamp that locks in behind the grab bar handle. The mount hangs below the bar, which keeps your gear out of the passenger airbag deployment zone, and it is designed not to press on, dent or scratch the factory leatherette. Install is a matter of wedging the top of the mount along the trim behind the passenger grab handle, sliding it into position and tightening the two top screws.
The phone holder charges any MagSafe compatible phone or case, and a metal adapter ring is included for phones that are not magnetic. The mount uses Tackform's Type-B interface and comes with a Type-B 20mm metal ball, so it lives on the 20 Series ball-and-socket system. The Type-B point can also take a 1-inch rubber ball or a 26mm aluminum ball if you run other mounting gear, and you can stack two or more LINK mounts along the grab bar for a multi-device setup.
Trade-offs
Passenger side only. Tackform does not publish a charging wattage for this head, and you will need to route a power cable to it. For proper clearance, run the arm and phone parallel to the grab bar rather than sticking straight out. 3.5-inch arms are the recommendation for phones, CB mics, radios and switch panels; tablets want a 5-inch or longer arm and a different setup.
Fitment
2024 and newer Jeep Wrangler JL and Gladiator JT, plus the 2024-2025 Wrangler 4xe, at the front passenger grab bar. Tackform lists it for 2024-and-up models only, so it is not the part for 2018-2023 JL or 2020-2023 JT grab bars.
Accent kit
Black is the base option. The other colors add a colored accent kit and cost a little more.
Questions before you order?
Fitment questions are easier to settle before the box ships. Call or text us at (920) 249-7744.
Complete your Jeep Gladiator build
More parts that fit your Jeep Gladiator and pair well with this one — matched and ready to install.
$90.00
$60.00
$40.00
$60.00
$75.00
More for your Jeep Gladiator
Picked from the 1730 parts we carry for the Jeep Gladiator, matched to 2024+ model years. Check the years and trim in each title — or call us and we’ll confirm fit.
2024+ Jeep Wrangler JL/4xe & Gladiator JT LINK™ Grab Bar Mount With MagSafe Charging Phone Holder & 3.5" Arm FAQs
Will it fit my 2021 Wrangler?
No. It is made for the 2024+ JL and JT and the 2024-2025 4xe passenger grab bar.
Does it go on the driver side?
No. Tackform designed it for the passenger grab bar.
Will it damage the grab bar wrap?
It is designed not to press on, dent or scratch the factory leatherette.
Can I add a second mount?
Yes. Two or more LINK mounts can go along the grab bar.
Multi-column
Join Our Community
For all things NVMOS, check us out on Instagram and Facebook!
Financing Available
Pay over time with Affirm or PayPal Credit at checkout, for qualified buyers.
Contact Us
Have a question? Just send us an e-mail at support@nvmos.com
