StickerFab Application Fluid (50ml)

Application Fluid (50ml)

This is the application fluid you were looking for.  Better than any mixture of soapy water, it allows for easier installations in a slightly wider range of temperatures.

It turns novices into at least intermediate level installers.  The initial surface tension of the sticky vinyl gets broken so you can dial in your alignment.  Push the fluid out and you are left with a spot on install.

Non-flammable.

INSTRUCTIONS

Shake before use.  Use in the shade if it is sunny and warm.

We recommend you clean the installation area with this application fluid OR a detail spray that doesn't have wax and THEN this application fluid if the area is really dirty.  Use a microfiber cloth to wipe dry.  Spray the back of your vinyl and then proceed like we instruct you in many of our installation videos.  Align, install, and squeegee or push out the remaining application fluid from under the vinyl.  Allow to dry.  Use of LIGHT heat can accelerate the initial bonding period.

If used with transfer tape, be sure the vinyl is dry enough to peel back the transfer tape without removing the vinyl (2-3 minutes after pushing as much application fluid out as possible).